VADPRO OBD2 Cable VAD15 – VAG/BMW CC22730

With it the installation is done in a few minutes all OBD 2 values can be shown on the display! Also engine error codes can be displayed!

OBD2 socket assignment

* If the CC22720 cable is used, pins 1 and 16 are not assigned, but are led out as a separate cable.

Can bus

The Can Bus settings must match the vehicle.By default, these are set that fit most vehicles:

< li >“Settings”: Speed = 500, CanTerm = ON

The display tests itself whether 11bit (Can2.0A) or 29bit (Can2.0b) identifiers are supported by the control unit.

Supported values

These values are preset and cannot be changed:

< li >Speed (RPM)

< li >Engine load

< li >Fuel Pressure

< li >Boost pressure (MAP)

< li >Vehicle speed

< li >Ignition angle (IgnAng)

< li >Intake temperature (IAT)

< li >Air mass (MAF)

< li >Oil temperature (Oil Temp)

< li >Fuel pressure relative to inlet vacuum (Fuel Rail)

< li >Water temperature (CLT)

< li >Lambda1-8

< li >Cat temperature bank1 sensor 1 (CatTemp1)

< li >Cat temperature bank1 sensor 2 (CatTemp2)

< li >Cat temperature bank2 sensor 1 (CatTemp3)

< li >Cat temperature bank2 sensor 2 (CatTemp4)

< li >Additionally 4 analog inputs

Analog inputs

In addition to the OBD2 values, sensors can also be fed in via the four analog inputs.

WARNING: Cancer and Reproductive Harm